Underhood Condenser Kit w/ 26"L X 16"W Multi Pass Condenser (BPE6690) fitting radiator opening of 22"inches Wide or Less,Universal Condenser mounting Brackets, Mini Receiver Dryer and Mounting Brackets,Hose Mounting Straps, Insulation, Fasteners,Barrier Hose Kit (#6-96", #8-60", & #10-72"), More than ample selection of all Bubble Crimp Fittings including #8 45 & 90 Degree Fittings w/ Charge Ports & #10 45 & 90 Degree Fittings w/ Charge Ports for installation at compressor.
This kit is Primarily used for NON Factory A/C Equipped Vehicles w/22" or less radiator opening. For Vehicles With Aftermarket A/C Evaporator. Includes Basic Installation Overview Instructions.
PICTURE SHOWN NOT REPRESENTATIVE OF ALL UNDERHOOD KITS, YOURS MAY VARY ACCORDING TO APPLICATION.
NOTE:1- On Most High Mounted Compressors, For Cleaner installation, we recommend mounting the compressor with both ,suction & discharge ports, pointing towards right side inner fender. Then use a pair of 45 degree fittings (BLA1312-3 & BLA1313-3) at compressor, and route hoses across top of Alternator.
2-Larger #8 Fitting Is always installed on top.
3-Smaller #6 Fitting is always installed at bottom. #6 Outlet fitting goes to Receiver Dryer .
4-Upon Installation, Always add 1/2-3/4 ounce of PAG 100 to Condenser Before Installation.
5-Condenser will be Under Nitrogen Pressure when caps are removed
6-Always fit largest condenser to opening in radiator support for maximum efficency and cooling
7-Some triming may be necessary at corners of Condenser Mounting Flanges for Fit on Some E Bodies and B Bodies.
8-Always mount Condenser as high as possible and as close as possible to radiator support opening.
9-When System is flushed Clean and dry, and you are using a NEW BPE provided Compressor, add 2-3 ounces (total) PAG 100 Refrigerant Oil to rest of the system, usually split between new condensor, evaporator, and fresh receiver dryer.
