Underhood Condenser Kit w/ 26"L X 16"W Multi Pass Condenser (BPE6690) fitting radiator opening of 26"inches Wide or More,Universal Condenser mounting Brackets, Single Action R134 Expansion Valve (BPE6640), Clutch Cycling Switch (BPE6696),Mini Receiver Dryer and Mounting Brackets,Barrier Hose Kit (#6-96", #8-60", & #10-72"), More than ample selection of all Bubble Crimp Fittings including #8 45 & 90 Degree Fittings w/ Charge Ports & #10 45 & 90 Degree Fittings w/ Charge Ports for installation at compressor.
This kit is Primarily used for Original Factory A/C Equipped A Bodies that had a 26" Radiator Support opening. Includes Basic Installation Overview Instructions.
PICTURE SHOWN NOT REPRESENTATIVE OF ALL UNDERHOOD KITS, YOURS MAY VARY ACCORDING TO APPLICATION.
NOTE:1- On Most High Mounted Compressors, For Cleaner installation, we recommend mounting the compressor with both ,suction & discharge ports, pointing towards right side inner fender. Then use a pair of 45 degree fittings (BLA1312-3 & BLA1313-3) at compressor, and route hoses across top of Alternator.
2-Larger #8 Fitting Is always installed on top.
3-Smaller #6 Fitting is always installed at bottom. #6 Outlet fitting goes to Receiver Dryer .
4-Upon Installation, Always add 1/2-3/4 ounce of PAG 46 to Condenser Before Installation.
5-Condenser will be Under Nitrogen Pressure when caps are removed
6-Always fit largest condenser to opening in radiator support for maximum efficency and cooling
7-Some triming may be necessary at corners of Condenser Mounting Flanges for Fit on Some E Bodies and B Bodies.
8-Always mount Condenser as high as possible and as close as possible to radiator support opening.
9-When System is flushed Clean and dry, and you are using a NEW BPE provided Compressor (which already has Oil in it), add 1.5-2 ounces (total) PAG 46 Refrigerant Oil to rest of the system, usually split between new condensor, evaporator, and fresh receiver dryer.
