Please note, we do NOT sell race fuel.
4705 Bracket Kit Fits B/RB Engines With NON-A/C Pulleys & Brackets W/O Power Steering
Fits B/RB Engines With NON-A/C Brackets, Pulleys, Without Power Steering
This Bracket Will Allow You To Mount A New Low HorsePower Robbing SPECIAL SHORT Sanden Compressor, Where the Power Steering Pump Is Normally Located!
The Compressor Will Line Up With Crank As The P.S. Did! Single Belt required but not included. approx. 39" long or BPE7390 Belt or Gates 7390XL HD Belt
Fits: All B & RB Engines. Most all Water Pump Housings manufactured (Cast Iron & Aluminum). All Intake Combo's. Without Power Steering.
NOTE: If your heads have the appearance of Original style Mopar Castings with an undercut ledge in the front and do not jut out too much, you may not have any issues. There Are No fitment issues with factory 906 or 452 casting cylinder heads. Some 1967 & earlier cylinder heads do require some clearancing of the front cast iron of the cylinder heads, cylinder heads like 915 and similiar castings
Will Fit SOME Engines with Aftermarket Heads. Most Aluminum Aftermarket Cylinder Heads have too much aluminum material left on the front face to clear (Edelbrock heads will not Clear). Be careful in determining actual clearance available. This is your responsiblity on Non Production Cylinder Heads.
Some 1967 & earlier cylinder heads do require some clearancing of the front cast iron of the cylinder heads, cylinder heads like 915 and similiar castings.
WILL NOT FIT STREET HEMIS OR CRATE HEMIS. WILL NOT WORK WITH MOST ELECTRIC WATER PUMPS.
Crank Pulley Required: BPE4012 (which works with BPE4014 Water Pump Pulley BPE5250 Alternator Bracket Kit)
Compressor Required: BPE7312 Sanden Style CP7H13 "Shorty"
Please note, we no longer sell race fuel.